World Wide Packets Lightning Edge 46 Manual Dexterity Examples Silversheen. Feather token, bird 3. Feather token, tree 4. Feather token, swan boat 4. 63.2 The World Wide Web. The next level (level 3) - is the level of interconnection, which is engaged in the transmission of packets using a variety of.

CA Performance Management On-Demand Certifications Certifications are packaged in ZIP files for easy installation. Each ZIP file includes a readme document with detailed information and post-installation steps. Ensure that all three items match your requirements before installing the certification. For more information on all supported certifications for existing CA Performance Management releases, see. If you require a new certification, please open a. The on-demand certification installation instructions can be found at the following URL:. Nikkai Remote Control Manual here. If the vendor certification priority requires a change as shown in the table below, follow the instructions to change vendor certification priorities at the following URL:.

• • Device Manufacturer Device Model CAPM Release Date Released Description Priority Change Required?

Makes Ethernet & Optical switches for the service provider market. There’s essentially zero publicly available documentation available which is a shame because they make some interesting equipment and as carriers upgrade there’s a lot of used equipment available that smaller providers can put to good use. I’m not sure why it’s traditional for telco-oriented companies to be stingy with their documentation but it’s annoying. I have some LE-311v, 3911, and a 3940 here for a project so here’s my notes.

They are applicable to all devices as far as I know unless otherwise noted. This also applies to devices running World Wide Packets LE-OS. Ciena acquired WWP and built their packet Ethernet offerings on tech from the acquisition. Configuration style CLI is subject-verb instead of verb-subject (think “interface show” not “show interface”). “configuration” enters config mode. Configuration is a blend of Cisco & Juniper Style: • JunOS: set system hostname lab • Cisco: hostname lab • Ciena: system set host-name lab You can view the current configuration with: configuration show The configuration is displayed as a sequence of commands that are entered to achieve the desired state when you are starting from the default state.

You save the configuration with: save You have to be in configuration mode to save the config but you don’t have to be configuration mode to change the configuration. You can navigate the configuration in a sort of tree format as on a Juniper or Mikrotik device. For example you can enter “interface remote show” to view management interface status or you can enter “interface remote” and then “show” or “set” as appropriate. Hardware reset to factory default I found someone else’s that covered this and got me started. On the LE-311v and 3940 there’s a pinhole reset button.

There’s three options: • Less than 2 seconds: soft reboot • Between 2 and 10 seconds: factory default • More than 10 seconds: hard reboot. Management access Default users There are two default users: su & user. Su is the superuser with a default password of wwp. User doesn’t have a password. Serial console My devices have a DB9 serial port. You’ll need a null modem cable for this. The 3911 has DB9 port visible from the user compartment but if you remove the inner cover to the carrier compartment you’ll see that it’s just a jumper to a Cisco-style cat5 console port.

The serial ports use the typical console settings of 9600 baud, 8 data bits, 1 stop bit, no parity (9600 8N1). Local Management Ethernet port The LE-311v & 3940 have a ethernet management port for local access. The local access part is important.

You can plug your laptop into it. You can’t put a default gateway or other route on it and hook it up to your out of band network. Management IP: 172.16.233.214/24.